Hi Daniela Dobson here and today I am sharing an shaker ornament I created. I recently made a shaker card that I absolutely loved and I thought how cool it would be if I made a similar one, but smaller, to hang on the tree. 

Shaker ornament by Daniela Dobson

Winter Scene Holiday Shaker Ornaments

Shaker ornament by  Daniela Dobson

Therm O Web Supplies:

Therm O Web 3D White Foam Squares Combo Pack
Therm O Web Zots™ Small
Therm O Web 3D White Foam Sticky Strips 1/2 in
Therm O Web Sticky Tape Mini Runner
Therm O Web Sticky Dot Mini Runner

Other Supplies:

Impression Obsession dies


Winter Scene Holiday Shaker Ornament Instructions:

1. Die cut the frames and adhere the two together using Therm O Web Sticky Tape Mini Runner.

Shaker ornament step 1 Daniela Dobson

2. Mark a window with a pencil and start layering your die cut pieces using Therm O Web Sticky Dot Mini RunnerTherm O Web 3D White Foam Squares Combo Pack, and Therm O Web Zots™ Small. Add sequins to the center.

Shaker ornament step 2 Daniela Dobson

3. Adhere a piece of acetate to the window opening. Add strips of Therm O Web 3D White Foam Sticky Strips 1/2 in around the edge of frame. I had to cut the strips just a little bit because the frame was just around 1/2 inch and I didn’t want any foam showing.

Shaker ornament step 3 Daniela Dobson

4. Position your window over the scene and adhere. Add a piece of patterned paper to the back. Attach clip and twine.

Shaker card tree by Daniela Dobson

Comments are closed.