Hi everyone! Daniela here today. I have a tip using 3D Foam Adhesive by Therm O Web.
I cut out the stamped image and I wanted to add dimension with 3D Foam Squares by Therm O Web.
I used the 1/4″ squares, but they were still too big. To make them smaller use your scissors, I used non-stick, and cut the 3D Foam Squares while they are still on the sheet and then remove them. That was so much easier than removing each individual square and cutting it.
I cut each 1/4″ 3D Foam Square in half.
I used Sticky Strip Runner by Therm O Web to adhere all my paper elements on the card.
Thank you for stopping by and I hope you find these tips helpful.
Have a great day.