Happy Holidays everyone!  It’s Lorrie here and I couldn’t wait to show you my homemade Christmas Ornaments.  I chose this fun 3D Snowflake ornament as well as this Petal Christmas Tree.  These ornaments were super simple to put together with a little help of my Thermoweb Adhesives.  Let’s start with the snowflake ornament



After using my Cricut Explore to cut out the pieces, I uses the iCraft SUPERTAPE™ to secure the ends of the Snowflake rosette together.  Supertape™ has extra hold and it perfect when you need to be sure your project stays puts.  Since this was the base of the ornament, it had to hold together and Supertape™ was the perfect solution.TOWInst1

Next, secure the Snowflake into a round rosette using the Thermoweb 3d Zots™ in the center of both the back and the front.  The 3d Zots™ provide dimension as well as extra hold in the center.


Add the final layers using the Thermoweb Mini Dot Runner.


Next up, the petal Christmas Tree.


Again, I used the SuperTape to ensure this project stayed together.   A quick spray of Gold Glitter Dust and the project had that extra finishing touch!




1 Comment on iCraft SuperTape Paper Ornaments

  1. Linsey
    December 12, 2014 at 10:41 am (6 years ago)

    So merry and bright! I love these! TFS 🙂