Hi Therm O Web fans!

It’s Katrina sharing a card made from three different colors of iCraft® Deco Foil™, one piece of pattern paper, a tag, and lots of ThermOWeb adhesive!  I used the iCraft® Deco Foil™ Foam Adhesive, along with some dies to make my card shiny and fun.


Therm O Web Supplies:
Therm O Web 3D White Foam Squares-1/2 inch
Therm O Web 3D White Foam Squares-1/4 inch
Therm O Web Sticky Dot Mini Runner
Therm O Web iCraft® DecoFoil™ – Lime
Therm O Web iCraft® DecoFoil™ – Magenta
Therm O Web iCraft® DecoFoil™ – Purple
Therm O Web iCraft® DecoFoil™ White Foam Adhesive

Other Supplies: Cardstock-American Crafts; Pattern Paper-WeRMemory Keepers; Dies-My Favorite Things

Start by placing your dies on your Deco Foil foam adhesive sheet.  Place them on the dull side of the backing paper, so that you can attach some washi tape to hold them in place when you run them thru your die cutting machine.  *note-I figured this out after I had taken my picture


Separate die cut pieces out and lay to the side.



Create card base and attach pattern paper, cut slightly smaller, to the front of card base with Sticky Dot Mini Runner.


Cover die cut pieces with Deco Foil and attach to front of card.  To create dimension use the 3D Foam Squares in 1/4 to lift the smaller layers above the card front.  Stick the foam square on back, then brush with baby powder to the areas of adhesive that are exposed, to eliminate sticking in places that you do not want.  Note-I have a tool to do this, but you can easily use a paint brush dipped into baby powder also.


Layer pieces on card front and send the card to someone special!



Thanks for stopping by the Therm O Web blog today!

Katrina Hunt

Paper, Scissors and Glue